track etching
英 [træk ˈetʃɪŋ]
美 [træk ˈetʃɪŋ]
网络 核径迹法; 径迹蚀刻
双语例句
- Effects of UV light illumination on track etching in polycarbonate
电导法研究紫外光预辐照对核孔膜径迹蚀刻的影响 - The chemical etching techniques of polypropylene ( PP) nuclear track membrane were studied. The effects of potassium dichromate concentration, sulfuric acid concentration, etching temperature and etching time on the bulk etching rate of PP nuclear track membrane were discussed.
探讨了蚀刻剂中重铬酸钾浓度、硫酸浓度及蚀刻温度、蚀刻时间等因素对聚丙烯膜基体蚀刻速率的影响； - Track Etch Dynamics Model of Isotropic Solid State Nuclear Detector at a Varied Etching Rate
各向同性固体核径迹探测器蚀刻速率比为变量时径迹蚀刻动力学模型 - Standardization Study on Confined Fission-Track Length Measurement& Study on Etching Standard of Zircon
裂变径迹长度测量标准化研究&锆石蚀刻标准探讨 - The computer simulation showed that the nuclear track membranes could prepared with cylinder pore by this method but it was difficult to control the etching process.
模拟计算表明，采用该方法可得到柱状孔核孔膜，但蚀刻过程很难控制。 - Numerical analysis of track etching process in polymers
聚合物离子径迹化学蚀刻过程的数值分析 - Determination of etching properties of CR-39 plastic track detector in different etching conditions
CR-39塑料径迹探测器在不同蚀刻条件下的蚀刻性能测试 - A method of determination of the relative sensitivities of cellulose nitrate track detector for the registration of protons is presented. By this method the optimum etching condition of the fuji film has been found.
本文提出一种测定硝酸纤维素径迹探测器纪录质子相对灵敏度的方法，并用该方法确定了富士膜的最佳蚀刻条件。 - Fission track etching condition of tourmaline
电气石裂变径迹蚀刻条件研究 - ^ The latent track etching of PET films irradiated by 40 Ar ions
高能Ar离子辐照聚酯薄膜潜径迹蚀刻 - Determination of Content of Boron in Solid Solution by Track Etching Method
硼钢中固溶硼含量的径迹照相法测定 - This work includes the separation of particles, disposing of the particle sample on the surface of nuclear track detector, irradiation of the sample by thermal neutrons and chemical etching, selection of uranium particles and so on.
研究内容包括擦拭样品与载体分离、样品在裂变径迹片上沉积、样品辐照以及化学刻蚀、铀微粒筛选等。 - The characteristics of polyethyleneterephthalate ( PETP) solid state nuclear track detector on registering fission fragment tracks are studied. The variations of average diameter of fission fragment tracks with etching temperature, etching time and etchant concentration were measured.
报道了聚乙烯对苯二酸酯（简称PETP）固体核径迹探测器时裂变碎片记录性能的实验研究.在改变温度、蚀刻时间和蚀刻液浓度等条件下测量了裂变碎片径迹平均直径的变化。 - Under certain etching conditions, the expected PP nuclear track membranes were made by etching the irradiated PP membrane, affirming the mathematical relation.
并选择一定的蚀刻条件对辐照过的聚丙烯膜进行蚀刻，得到了预期孔径的聚丙烯核孔膜。